National Service hotline:

0451-86708047

Current Location:homepage > News center > Company news

Heilongjiang latex paint flow hang, breed mold to do

Release time: 2023-04-05 08:29:14

News source: Heilongjiang Haole Jia building Materials Co., LTD

  Heilongjiang latex paintHow to hang, breed mold
  Flow-hanging refers to the phenomenon of paint flowing lines on the surface of the coated film after painting, and the phenomenon of paint accumulation under the ripples。
  Reasons: such as due to too much water resulting in too low paint viscosity and flow hanging, one-time coating is too thick resulting in flow hanging, uneven substrate, too much corner paint, latex paint itself quality problems will lead to flow hanging。
  Prevention: In order to avoid flow hanging, we must first ensure that the wall is smooth, water according to the manufacturer's requirements during construction, ensure that the paint viscosity is moderate, and one-time brushing/spraying can not be too thick。

  Treatment: The paint film appears to hang, and after it is dried naturally, the paint film that has the flow hanging problem is polished and smooth, and then painted again。

Heilongjiang latex paint


  Heilongjiang latex paintmildew
  Reasons: humid air, less sunshine;Brush paint on moldy walls;Paint film defects due to paint or construction problems are prone to mold growth。
  Prevention: You can choose a mildew resistant latex paint, remove mildew substances on the substrate before construction, and standardize the construction to ensure that the paint film is complete, no shrinkage holes or vacancies。
  Treatment: It is recommended that you remove and polish off the mouldy part of the paint film, and then clean the wall with mildew resistant solution or bleaching solution, and re-apply mildew resistant latex paint after thorough drying。
Hot spot recommendation